American Fibertek SM24p-POE RSTP Quick Setup Procedure - Manual

SOP
SM24p-
POE
Rev 000
RSTP Quick Setup Procedure for the SM24p-POE
t
9/24/2012
Page
1 of 2
1. Purpose
The following is a recommended quick setup for (RSTP) rapid spanning tree configuration
in a system. This document has been provided to define a quick start procedure.
2. Procedure
1. Default IP address of the switch is 192.168.1.77. Configure a PC on the 192.168.1.0 sub net.
An example of an IP to assign to the PC would be 192.168.1.2.
2. Connect a RJ45 patch cable between port 1 of the switch and the PC. Check the link indicator
to ensure proper connectivity.
3. Configure the IP for the switch. The system has the default IP address. You can
re-configure or use the default value. Configure the following parameters using a web browser
at
http://192.168.1.77 . When prompted for the login password, use the default password
which is admin. Navigate to the system configuration page.
a. IP Address: assign the switch IP address. The default IP is 192.168.1.77
b. Subnet Mask: assign the switch IP subnet mask.
c. Gateway: assign the switch gateway. The default value is 192.168.1.254
e. Select action to save the configuration.
[NOTE] Always restart the switch after finished the setup.
4. After restart, log in to switch again with the new IP address assigned (if any). Navigate to the
RSTP configuration. Check the the Mode parameter is set to RSTP. Navigate to the RSTP Port
Configuration section and enable RSTP on the redundant link ports by checking the check boxes next
to the appropriate ports. In the illustration in this document, the ports would be 21,22,23,24.
5. Repeat the above steps for other switches to be installed in the system, and be sure to assign
unique IP addresses to each switch.
6. Bench test the entire system before installing in field to ensure correct operation. Be sure that
all devices maintain connectivity under normal conditions and when either of the redundant
links is lost. Refer to Figure 1 for an example of a system under test.