American Fibertek MXR4-100TX - Manual (Page 2)

2
INSTALLATION AND OPERATION INSTRUCTIONS
INTRODUCTION
Thank you for purchasing your American Fibertek MXR4-100TX series network switch. Please take a
few minutes to read these installation instructions in order to obtain the maximum performance from
this product.
FUNCTIONAL DESCRIPTION
The MXR4-100TX series combines four copper Ethernet ports. MXR4-100TX units allow transmission
speeds of 10 Mb/s or 100 Mb/s on each of the copper ports. Refer to the data sheets for detailed
performance specifications.
The MXR4-100TX series is configured to auto negotiate the data ports to either 10Base-T or 100Base-
TX Ethernet data at full or half duplex. The auto negotiate feature also selects the proper MDI or MDIX
interface.
This unit is contained in a compact and rugged aluminum housing with internal dc voltage regulation.
The detachable terminal block, RJ45 Ethernet data connector, and LED indicators provide for easy
installation and monitoring of data and dc power. The MXR4-100TX is designed for rack mounting in
the MXRC-1 subrack. For mounting as a modular stand alone unit see the MX4 series.
INSTALLATION
THIS INSTALLATION SHOULD BE MADE BY A QUALIFIED SERVICE PERSON AND SHOULD
CONFORM TO THE NATIONAL ELECTRICAL CODE, ANSI/NFPA 70 AND LOCAL CODES.
MXR4 series units slide into any open slot in the MXRC-1 subrack. Use a small screwdriver to screw
the top and bottom fasteners into place.