American Fibertek MT-913 - Manual (Page 3)

3
Service Information...................................................................................... 8
INSTALLATION AND OPERATION INSTRUCTIONS
INTRODUCTION
Thank you for purchasing your American Fibertek MT-913 multimode video transmitter with bi-
directional multi-protocol data. Please take a few minutes to read these installation instructions in order
to obtain the maximum performance from this product.
FUNCTIONAL DESCRIPTION
The MT-913 operates as half of a transmitter / receiver pair for the transmission of high performance 10
bit digital NTSC, PAL, RS170, or RS343 video signals. The MT-913 also supports up to three bi-
directional channels of RS485 (2 or 4 wire), RS422, RS232 or Manchester data. Switch selection
allows for multiple data configurations in one of the following three formats:
Channel 1: RS422 or RS232 data
Channel 2: RS422 or RS232 data
Channel 3: RS422 or RS232 data
Or:
Channel 1: RS422 or RS232 data
Channel 2: RS485 (2 or 4 wire) or Manchester data
Channel 3: RS422 or RS232 data
Or:
Channel 1: RS485 (2 or 4 wire) or Manchester data
Channel 2: RS485 (2 or 4 wire) or Manchester data
Channel 3: Not available in this configuration
NOTE: This unit is shipped in the following default configuration. For other configurations,
please refer to the DATA CONFIGURATION section for changes to the default switch settings.
Channel 1: RS422 data
Channel 2: RS485 (4 wire) or Manchester data
Channel 3: RS232 data
The MT-913 is designed to operate with the MR-913 or RR-913 video receiver with bi-directional data
over one multimode fiber optic cable.
The MT-913 multiplexes a single video input signal along with up to three data signals into a high
speed serial data stream. This serial data stream modulates a laser at 1310 nm wavelength. The MT-
913 also detects and demultiplexes a return optical serial data stream signal containing up to three data
channels at 1550 nm wavelength. The 913 Series product is designed to operate over an optical loss
budget range of 0 to 12 dB. Refer to the data sheets for detailed performance specifications.
The RS485 channel may be configured for 2-wire (half duplex) or 4-wire (full duplex) operation with or
without biasing. Switch selectable internal 120 ohm terminations are available for RS422 or RS485
data.
This unit is contained in a rugged aluminum housing with internal dc voltage regulation. The detachable
terminal blocks and LED indicators provide for easy installation and monitoring of video, data, and
optical power.
The MT-913 is designed for mounting as a modular stand alone unit. For a rack mounted version
please see the RT-913.