American Fibertek RR-913C-SL - Manual (Page 3)

3
INSTALLATION AND OPERATION INSTRUCTIONS
INTRODUCTION
Thank you for purchasing your American Fibertek RR-913C-SL singlemode video receiver with bi-
directional multi-protocol data. Please take a few minutes to read these installation instructions in order
to obtain the maximum performance from this product.
FUNCTIONAL DESCRIPTION
The RR-913C-SL operates as half of a transmitter / receiver pair for the transmission of high
performance 10 bit digital NTSC, PAL, RS170, or RS343 video signals. The RR-913C-SL also supports
up to three bi-directional channels of RS485 (2 or 4 wire), RS422, RS232 or Manchester data. Switch
selection allows for multiple data configurations in one of the following three formats:
Channel 1: RS422, RS485-(2 or 4 wire), Manchester, or RS232 data
Channel 2: RS422, RS485-(2 or 4 wire), Manchester, or RS232 data
Channel 3: RS422, RS485-(2 or 4 wire), Manchester, or RS232 data
NOTE: This unit is shipped in the following default configuration. For other configurations,
please refer to the DATA CONFIGURATION section for changes to the default switch settings.
Channel 1: RS422 data
Channel 2: RS485 (4 wire) or Manchester data
Channel 3: RS232 data
The RR-913C-SL is designed to operate with the MT-913C-SL or RT-913C-SL video transmitter with bi-
directional data over one singlemode fiber optic cable.
The RR-913C-SL multiplexes up to three data signals into a high speed serial data stream. This serial
data stream modulates a laser at 1550 nm wavelength. The RR-913C-SL also detects and
demultiplexes a return optical serial data stream signal containing a single video input signal along with
up to three data channels at 1310 nm wavelength. The 913C-SL Series product is designed to operate
over an optical loss budget range of 0 to 21 dB. Refer to the data sheets for detailed performance
specifications.
The RS485 channel may be configured for 2-wire (half duplex) or 4-wire (full duplex) operation with or
without biasing. Switch selectable internal 120 ohm terminations are available for RS422 or RS485
data.
This unit is designed for rack mounting in either of two American Fibertek subracks available. The
subrack model numbers are SR-20/2 or SR-20D/2. Slide in rack mounting, detachable terminal blocks,
and LED indicators provide for easy installation and monitoring of video, data, and optical power.
The RR-913C-SL is designed for rack mounting only. For a modular stand alone version please see the
MR-913C-SL.