American Fibertek MRX-8689C-SL - Manual (Page 9)

9
MRX-8689C-SL STATUS INDICATORS
The MRX-8689C-SL receiver provides the following front panel LED status indicators to aid in
installation and troubleshooting:
DATA
These indicators turn green when any data activity is present. An active DATA TX LED indicates
data is present at the input terminals to the MRX-8689C-SL. An active DATA RX LED indicates
data is present at the output terminals of the MRX-8689C-SL. When configured for contact
closure, the Tx and Rx LEDs will be off to indicate contact open and on to indicate contact
closed. When configured for RS-485, an active Hi-Z LED indicates the MRX-8689C-SL has
seized the data line to allow data flow. The intensity of the indicators will vary with input data
patterns, however, the Hi-Z LED will typically appear dimmer than the data Tx and Rx LEDs.
The data channels associated with these front panel DATA LEDs are listed below.
Configuration Protocol DATA 1 TX DATA 1 RX DATA 2 TX DATA 2 RX
RS485 RS485 Tx RS485 Rx Hi-Z Hi-Z
RS422 RS422 Tx RS422 Rx Not Used Not Used
Contact Closure Not Used Not Used Contact State Contact State
RS422/Contact Closure RS422 Tx RS422 Rx Contact State Contact State
OLI 1
A bi-color LED indicator monitors the power of the optical input signal that is being received at
the MRX-8689C-SL from video channels one through four of the MTX-8689C-SL. AC power and
optical input status associated with this LED are summarized below. Please note that data is
sent as a subcarrier on channel one’s video signal.
Optical Level Indicator AC Power Status Optical Status
Green On Proper Optical Input Power Present
Red On Optical Input Not Detected
Off Off Check Power Supply Input
OLI 2
A bi-color LED indicator monitors the power of the optical input signal that is being received at
the MRX-8689C-SL from video channels seven and eight of the MTX-8689C-SL. AC power and
optical input status associated with this LED are summarized below.
Optical Level Indicator AC Power Status Optical Status
Green On Proper Optical Input Power Present
Red On Optical Input Not Detected
Off Off Check Power Supply Input