American Fibertek RRX-486 - Manual (Page 3)

3
POWER CONNECTION
Power is supplied to the unit via a four finger backplane connector. The RRX-486 can be inserted into the
subrack or removed from the subrack with power applied to the backplane.
FIBER INPUT / OUTPUT CONNECTION
The fiber optic connection is made via a ST connector located on the back of the unit. Be sure to allow
sufficient room for the required minimum bend radius of the fiber cable used.
DATA INPUT / OUTPUT CONNECTION
The data input / output connection is made via a RJ12 connector on the back of the unit.
DATA CONFIGURATION
The RRX-486 is shipped from the factory in the Panasonic PSD data configuration. This unit is
designed for use with Panasonic PSD data only. All internal switches should remain in the
configuration set at the factory.