American Fibertek MT-81SL - Manual (Page 3)

3
POWER CONNECTION
Power is supplied to the unit via a two pin terminal connector on the right side of the unit. See label on
unit for proper location of input power.
FIBER OUTPUT CONNECTION
The optical output connection is made via a FC/PC connector located on the right side of the unit.
CONTACT CLOSURE INPUT CONNECTIONS
Contact closure input connections are made via terminal blocks attached to the right side of the unit.
Please note that the two Channel 1 inputs begin at the second terminal screw closest to the fiber
connection on each of the two nine pin terminal strips. Channels 2 through 8 connections continue
down the terminal strip. For optimum performance the copper cables carrying the contact closure signal
should be the shortest length of wire practical.