GE ZIFP360NXRH - Manual

OVERALL DIMENSIONS
Product Specification Created 3/14
ZIFP360NXRH GE Monogram ® 36" Built-In All-Freezer
36 3/4"
(93.4)
TOP VIEW
35"
(89.0)
Case width
36"
(91.5)
25 3/4"
(65.4)
23 7/8"
(60.7)
*84"
(213.4)
2 3/4"
(7.0)
*73 1/4"
(186.1)
*3 1/2"
(8.9)
*83 1/2"
( 212.1)
30 1/2"
(77.5)
*31 3/4"
(80.6)
ZIFP360NXRH
SIDE VIEW FRONT VIEW
* Shipping height. Use leveling legs and wheels for maximum
1" height adjustment from shipping height.
** Allow 5" (12.7) min
clearance to a wall
for 90˚ door swing
**These units are equipped with a 2-position door stop. The factory set 130° door swing can
be adjusted to 90° if clearance to adjacent cabinets or walls is restricted. Allow 15" minimum
clearance to wall for pan removal. If the 90˚ door stop position is used, pan access is
maintained but pan removal is restricted.
** Allow 25" (63.5) min
clearance for 130˚
door swing
ATTENTION ELECTRICIAN:
A 115 volt 60Hz., 15 or 20 amp power supply
is required. An inidividual properly grounded
branch circuit or circuit breaker is recommended.
Install a properly grounded 3-prong electrical
receptacle recessed into the back wall.
SPECIFICATIONS
Overall Width 36" (91.4 cm)
Overall Height 84" (213.4 cm)
Overall Depth 25 3/4" (65.41 cm)
Door Clearance 36 3/4" (93.4 cm)
Cutout Width 35 1/2" (90.2 cm)
Cutout Height 83 1/2" - 84 1/2"
(212.1 - 214.6 cm)
Cutout Depth 24" (61 cm)
Plumbing Requirements 1/4" OD copper
tubing or GE
SmartConnect kit
Shipping Weight 569 lb
Dimensions in parentheses are in centimeters unless otherwise noted.
Actual product dimension may vary due to manufacturing tolerances.
36 3/4"
(93.4)
TOP VIEW
35"
(89.0)
Case width
36"
(91.5)
25 3/4"
(65.4)
23 7/8"
(60.7)
*84"
(213.4)
2 3/4"
(7.0)
*73 1/4"
(186.1)
*3 1/2"
(8.9)
*83 1/2"
( 212.1)
30 1/2"
(77.5)
*31 3/4"
(80.6)
ZIFP360NXRH
SIDE VIEW FRONT VIEW
* Shipping height. Use leveling legs and wheels for maximum
1" height adjustment from shipping height.
** Allow
5"
(12.7) min
clearance to a wall
for 90˚ door swing
**These units are equipped with a 2-position door stop. The factory set 130° door swing can
be adjusted to 90° if clearance to adjacent cabinets or walls is restricted. Allow 15" minimum
clearance to wall for pan removal. If the 90˚ door stop position is used, pan access is
maintained but pan removal is restricted.
** Allow
25"
(63.5) min
clearance for 130˚
door swing