GE ZFSB25DXSS - Manual (Page 2)

108
Advance planning for free-standing refrigerators
Product dimensions
36"
72"
27-1/2"
(29-1/2" Including
Handles)
ZFSB23DxSS
Installation note:
Doors and passageways into the installation location require
a 36" minimum opening. If the opening is less than 36", the top
cap and doors must be removed. See installation instructions
for details.
Electrical
A 115V, 60Hz., 15- or 20-amp power supply is required. An
individual properly grounded branch circuit or circuit breaker is
recommended. Install a properly grounded 3-prong electrical
receptacle recessed into the back wall.
This serial plate is located inside the fresh food compartment,
at the top and on the right side.
Note: GFI (ground fault interrupter) is not recommended.
Water line
The water line can enter the opening through the floor or back
wall. Route GE SmartConnect
™ kit or 1/4" O.D. copper tubing
between the cold water line and the water connection location
at the rear of the refrigerator. The installation of an easily
accessible shut-off valve in the water line is required.
Door swing clearances
The installation must allow for clearances to adjacent walls or
cabinets. These refrigerators are factory set for a 160° door swing.
605Dia43
19"
14-1/4"
ZFSB25 and ZFSB23
160 °
160 ° Door Swing
605Dia44
90 ° Door Swing
ZFSB25
24-5/8"
22"
ZFSB23
24"
22"
4" Min.
to Wall
Allow 19" minimum clearance on the fresh-food side for a full
160° door swing and pan removal. Allow 14-1/4" clearance on
the freezer side for removal of ice bin.
• 4" minimum clearance is required when the door swing is
restricted to 90°.
Air circulation clearances
For proper air circulation allow 1/8" clearance on each side,
and 1" clearance at the top and back side.
ZFSB25DxSS
72"
36"
28-1/2” Depth
(30-1/2"
Including
Handles