GE GVS04BDWSS - Manual (Page 8)

8
Care and cleaning.
If the power fails, open the door as
infrequently as possible to maintain the
temperature. A gradual rise in temperature
should not have any adverse effect on the
wine.
If it is extremely hot, you may want to unload
the wine from the beverage center/wine
chiller and move the wine to a cooler location
until power is restored.
The controls may maintain your temperature
settings when the power has been restored. If
your settings are not correct, reset according
to the Control Settings section.
In the Event of a Power Failure
Unload the wine, then secure the racks by
taping them in place to prevent damage.
Be sure the beverage center/wine chiller stays in
an upright position during the move.
Preparing to Move
Replacing the light bulb.
Unplug the beverage center/wine chiller.
Remove any beverages and shelves as needed for access.
The light bulb is located behind a light shield in the ceiling of the beverage
center/wine chiller near the back. To remove the light shield, remove the
screw on the right side of the light shield.
Pull down on the back of the light shield to release the two front tabs.
Unscrew the light bulb from the socket.
Replace with a 15 watt, 120 volt bulb. This type of bulb is available at most
hardware and automotive parts stores.
WARNING:
Using a bulb rated higher than 15 watts may
damage the electronic controls on the beverage center/wine chiller.
Reinstall the light shield.
Replace the top shelf and beverages.
Plug in the beverage center/wine chiller.
Light Shield
Screw