Aussie Vantage LP 6703T8DV31 - Manual (Page 10)

10
Step 9
Side Burner Valve Assembly
NOTE: Side Burner Valve is already attached to the regulator hose. Hose is not shown in illustration for clarity.
A. Install the Side Burner Valve from underneath the LEFT Side Table. First insert the valve stem out through the hole in
the bezel and fascia on the front of the side table. Next, flex the tube of the burner down and insert the nozzle into the
opening in the burner tube.
B. Install two 5/32” x .31” Bolts through the Control Knob Bezel and front of Side Table and into the threaded Valve
bracket holes. Install the top bolt first by twisting the valve/bracket to align only the top holes. Do not tighten completely.
Next, twist the valve/bracket to align the bottom holes and install the second bolt. Tighten both bracket holes.
B
Step 10
Side Burner Igniter Wire Connection
The Side Burner Igniter Wire is pre-installed and connected to the Igni-
tion Box. Attach the wire to the Side Burner electrode by sliding the wire
connector onto the electrode terminal.
Underside view of
Side Table/Side Burner
Note:
Shown without Regulator
Hose for clarity.
Valve
A
5/32 x .31” Bolt
2 pc
B
Top First
Bottom Second