beautypg.com

GE GTUN275GMWW User Manual

Gtun275em/gm, 27" unitized spacemaker, Installation instructions

background image

Dimensions and Installation Information (in inches)

For answers to your Monogram,

®

Cafe

Series,

Profile

Series or GE

®

appliance questions, visit

our website at geappliances.com or call GE

Answer Center

®

service, 800.626.2000.

360330

GTUN275EM/GM

GE

®

27" Unitized Spacemaker

®

3.4 DOE Cu. Ft. Stainless Steel Washer and 5.9 Cu. Ft. Dryer

Listed by

Underwriters

Laboratories

Specification Revised 1/14

Electrical Requirements:

GTUN275EM Electric Dryer – This appliance should be connected to an

individual, properly-grounded branch circuit with 120/240V or 120/208V

single-phase 60 Hz electrical service and should be protected by

30-amp time-delay fuses or circuit breakers KW Rating per voltage

(240/208). This appliance is manufactured with neutral connected to the

frame. Power cord should be purchased separately.
Note:

These appliances are not approved for 120-volt operation.
Gas Requirements:

GTUN275GM Gas Dryer – This appliance should be connected to an

individual branch circuit with 120-volt single-phase 60 Hz electrical

service and should be protected by 20-amp time-day fuses or circuit

breakers. This appliance is equipped with a 4-foot long flexible U.S. listed

20-amp power cord to match a 20-amp receptacle.
Note:

Gas Rated input 20,000 BTU/HR. Factory equipped for natural gas. Tested

for LP gas.

LP gas supply requires a conversion kit. Have a qualified gas

technician install a conversion kit before use.

Dryers

must be exhausted to the outside.

Installation Information:

For complete information, see installation instructions packed with

the product.

Installation Instructions

* Dimension represents door closed including handle and knobs.

NOTE: With feet set at mid position, feet can be adjusted ±.38"

27" NOMINAL PRODUCT DIMENSIONS

Vent

Drain outlet

51°

Gas Inlet

Water Inlets

*26-3/4"

34-7/8"

4-3/8"

3"

47"

18-5/8"

12-1/2"

75-1/2"

52-7/8"

3-7/8"

36-1/2"

30-7/8"

26-3/4"

20-1/5"

3"

This manual is related to the following products: