Setting button – Avenview SW-VGA-5X5 User Manual
Page 9
www.avenview.com
9
1. Setting Button
Click Get button to read back device ID.
Click Set button to write device ID.
Click Rename button to open the String Table.
For Ethernet
1
group, users have to define Ethernet
properties through RS-232 for the matrix. All the
parameters for Ethernet have to be saved into the matrix
by clicking on Write To Device button.
In the Communication
2
group, users can choose the
control interface between matrix and PC host.
1
Initial or any change to Ethernet settings, users MUST power cycle VGA matrix in order to
get the network settings effective!
2
Please notice that Ethernet control has a higher priority than RS-232. If RS-232 and Ethernet
controls come from 2 different hosts, commands may coincide and in this case, commands from
Ethernet will be effective immediately no matter whether commands from RS-232 are accurately sent
and executed!