Alto-Shaam HALO HEAT 500-TH-II - Manual (Page 11)

TH-II serIes • InsTallaTIon / operaTIon / servIce manual - pg . 9
S I T E I N S T A L L A T I O N
I N S T A L L A T I O N
drIp TrAy INSTALLATION INSTrucTIONS
d A N G E r
ENSURE POWER SOURCE
MATCHES VOLTAGE STAMPED
ON APPLIANCE NAMEPLATE.
Item Description Qty
1 Double-Sided Tape 1
2 Drip Tray Holder 1
3 8-32 x 1/4” Phil Screw 3
4 Drip Tray 1
1. Poke holes through double-sided tape a which is attached to the back of drip tray holder b .
2. Remove backing on double-sided tape a .
3. Put screws c through holes and attach drip tray holder b to unit .
4. Optional - apply a line of food-grade silicone caulk along top edge of drip tray holder b to seal .
5. Place drip tray d in drip tray holder b .
a b
c
d