Asus Book Size Barebone System Prodigy - Manual (Page 18)

18 Chapter 2: System Assemby
2.4 Install system memory
1. Set the CD and floppy disk drive assemply on the side of the chassis.
2. Locate the two DDR SDRAM DIMM sockets on the ASUS
motherboard.
6. After installing the
DIMM, place the CD and
floppy drive assembly
back into its original
position. Then, replace
the front bezel; take care
to insert the three plastic
tabs without stress.
®
184-Pin DDR DIMM Sockets
80 Pins
104 Pins
3. Unlock a DIMM socket
by pressing the retaining
clips outward.
4. Align a DIMM on the
socket such that the
notch on the DIMM
matches the break on
the socket.
5. Firmly insert the DIMM
into the socket until the
retaining clips snap back
in place and the DIMM is
properly seated. CAUTION
A DDR DIMM is keyed with a notch
so that it fits in only one direction.
DO NOT force a DIMM into a socket
to avoid damaging the DIMM.