Before using your portable washer, Selecting a location, Installation instructions – Avanti W758PS User Manual
Page 9
9
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR PORTABLE WASHER
• Remove the exterior and interior packing.
• You will need the following tools:
• Wrench
• Pliers
• Screwdriver
• Check to be sure you have all of the following parts:
• 2 Inlet Hoses
• 2 Faucet Adapters
• 1 Noise Proof Plate With Screws
• 4 Rubber Washers
• 4 Casters
• Remove shipping brace. Note - It should be saved and used (to prevent damage to washer
components) whenever washer is moved or transported to a new location.
• Clean the interior surface with lukewarm water using a soft cloth.
• Allow 2 inches of space between the back and sides of the appliance.
• Put your laundry into the washer evenly. Uneven laundry may cause noise or vibration.
• DO NOT use excessively hot water (122ºF / 50°C or more). Plastic parts may be deformed or
damaged. Also, clothing may be deformed or bleached.
• Before washing, check all pockets. If nails or pins remain in pockets, they may damage the
washer or clothes.
• Never splash water on the control panel.
• Plug the washer into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
Authorized Avanti Products service center.
SELECTING A LOCATION
Before you install the portable washer, select a location with the following
characteristics:
• A hard level surface (if the surface is uneven, see Adjusting The
Adjustable Foot section on the next page).
• Away from direct sunlight. Direct sunlight may affect the acrylic coating,
plastic and electrical components.
• Adequate ventilation.
• Away from sources of heat such as coal or gas. Make sure that the
washing machine does not stand on its power cord.
• Ventilation openings must not be obstructed by carpeting when the
portable washer is installed on a carpeted floor. It is recommended
that you place your portable washer on a hard material floor such as tile,
concrete, linoleum and to avoid if at all possible placement on wooden floors
or carpeted areas.
WRENCH
PLIERS
SCREWDRIVER