Atlantic Technology SB-900 - Manual (Page 3)

3
Instruction Manual
Low Level Input
Use the input to connect to the subwoofer or LFE line out from
your processor/receiver.
High Level Output
Connect main Left/Right speakers here when using the High
Level Input.
High Level Input
If your electronics do not have a line-level sub out, connect the Left-
Right speaker terminals of your electronics to these connections.
Set the SB-900’s crossover to “Lowpass,” and adjust accordingly.
AC Input
Use the included power cord to connect your amplifier to a wall
outlet.
Voltage Select Switch
Voltage switch for use in different countries. This switch will be set
when you receive the unit. Change this setting only when you are
sure your application requires it. For US, the switch should be set
to the 115V position.
Product Serial Number
Write this number in the space provided on page 2 for future
reference.
FOR CONTINUED PROTECTION AGAINST RISK OF FIRE,
REPLACE ONLY WITH SAME TYPE AND RATING OF FUSE
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK. DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
DOUBLE INSULATION - WHEN SERVICING,
USE ONLY IDENTICAL REPLACEMENT PARTS
SERIAL
MODEL
SB900BJRWWY80100
SB-900-BLK Powered Subwoofer
AUTO
OFF ON
PHASE
INVERT NORMAL
LEVEL LOWPASS
BYPASS
LOW LEVEL
RIGHT
L / MONO STATUS
HIGH LEVEL
INPUT OUTPUT
RIGHT RIGHT L / MONO L / MONO
AC INPUT
50-60 HZ 180W MAX
FOR 110-120V, USE T2AL 250V FUSE
FOR 220-240V, USE T1AL 250V FUSE
110-120V
220-240V
MIN MAX 40 220
80
ENGINEERED IN THE USA,
MANUFACTURED IN CHINA
Status LED
This will be green for "on" condition, red for "standby"
Standby Switch
When in ON position, the amplifier will always be on. When in the
AUTO position, the amplifier will be in Automatic Standby Mode.
Phase Switch
This switch allows precise acoustic matching with satellite speaker
systems whose output may be phase reversed. Try in both the
highest and lowest positions — use the position that results in the
strongest bass output.
Bass Level Control
Use this control to set the level of bass desired
Low-Pass Control
An adjustable (55Hz to 200Hz) @ 18dB per octave low-pass
crossover.
Low-Pass Switch
When in the LOW-PASS position, adjustment of the crossover can
be made by the Crossover Control. If being fed a pre-filtered or THX
signal, place the switch at the BYPASS position.
1
4
3
2
10
8
9
SB-900 Subwoofer Rear Panel
Figure 1
2
10
11
4 5 3
7
12
5
1 7 6
8
9
6
11
12
SB-900 Manual.indd 3 10/18/10 3:19:35 PM