Specifications, Line drawings, Pt 4000 bodypack – AKG Acoustics HT 4000 User Manual
Page 2: Ht 4000 handheld, Architects and engineers specifications
Line Drawings
(us standard and metric measures)
Specifications
PT 4000 Bodypack
Audio Bandwidth: 35 –20,000 Hz
Carrier Frequency Range: 650 – 680, 680 – 710, 720 – 750, 760 – 790,
790 – 820, 835 – 863 MHz
Carrier Frequencies: up to 1,200
Modulation Method: FM
Rated Deviation:
±20 kHz nominal
S/N Ratio (A-weighted): > 120 dB(A)
Radiated RF Power: 50 mW ERP
Audio Input: Mini XLR, 3 pin
Current Consumption: < 135 mA
Power Requirement: 2 AA 1.5-V batteries or BP 4000 rechargeable pack
Typical Battery Life: Alkaline batteries, 15 hours; BP 4000: 12 hrs.
Size: 2.8 x 3.5 x 1 in. (70 x 90 x 25 mm)
Net Weight: 11.3 oz. (320g) without batteries
HT 4000 Handheld
Audio Bandwidth: 35 –20,000 Hz
Carrier Frequency Range: 650 – 680, 680 – 710, 720 – 750, 760 – 790,
790 – 820, 835 – 863 MHz
Carrier Frequencies: up to 1,200
Modulation Method: FM
Rated Deviation:
±20 kHz nominal
S/N Ratio (A-weighted): > 120 dBA
Radiated RF Power: 50 mW ERP
Input Level: 140 dB-SPL @ nominal deviation
Current Consumption: <125 mA
Power Requirement: 2AA 1.5-V batteries or rechargeable pack BP 4000
Battery Life: Dry batteries, 15 hours, BP 4000: 12 hrs.
Size: lenght: 9.4 in. (239 mm); diameter: 1.5 in. (39 mm)
Net Weight: 11.3 oz. (320g) without batteries
Architects and Engineers Specifications
The wireless system shall operate over a 30 MHz UHF frequency range
in one of 6 bands from 680 to 863 MHz, with a wide range of possible
frequency settings. The wireless microphone system shall incorporate
factory-optimized sets of both transmission and receiving frequency
modules that are programmed into both transmitters and receivers. Each
frequency set shall comprise a 30 MHz UHF band and offer up to 1,200
discrete operating frequencies within that band, with transmitter power
not exceeding 50 milliwatts. Both handheld and bodypack type trans-
mitters shall be provided. The bodypack transmitter shall accommodate
both microphone and line level inputs. The transmitters shall operate
with a companding system that is complemented by the receiver,
providing an A-weighted system dynamic range in excess of 120 dB.
The transmitters shall indicate input overload via an LED indicator and
on a backlit display battery lifetime shall be displayed in hours as well
as the transmitting frequency. Handheld transmitters shall have a
maximum diameter of 39 mm and a length, including antenna, no greater
that 239 mm. The wireless microphone system shall be the AKG
Acoustics Model WMS 4000.
3.5 inch (90 mm)
2.8 inch (70 mm)
1 inch
(25 mm)
9.4 inch (239 mm)
ø 1.5 inch (39 mm)
AKG Acoustics GmbH
Lemböckgasse 21–25, P.O.B. 158, A-1230 Vienna/AUSTRIA,
Tel.: (+43 1) 86 654-0*, Fax: (+43 1) 86 654-7516, www.akg.com, e-mail: [email protected]
Hotline: (+43 676) 83200 888, [email protected]
AKG Acoustics, U.S.
914 Airpark Center Drive, Nashville, TN 37217, U.S.A.,
Tel.: +1-615-620-3800, Fax: +1-615-520-3875,
www.akgusa.com, e-mail: [email protected]
For detailed information on WMS 4000 and other products from AKG contact your dealer
or visit www.akg.com
Specifications subject to change without notice.
02/04/Proa-Nr. 1453
www.akg.com