Air King 3C614C - Manual

READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED.
PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
DESCRIPTION
The AirKing 20" (50.8 cm) Whole House Window Fan features three
intake and three exhaust speeds. Fan will fit windows 27" (68.6 cm) to
38" (96.5 cm) wide x 26-1/4" (67.3 cm) high. The adjustable side panels
are designed to accommodate Fan mounting either inside or outside
interior window trim. The 3-paddle Fan blade is driven by a permanently
pre-lubricated permanent split capacitor motor with 6' (1.8 m), 18/3 cord set.
SPECIFICATIONS
Motor ....................................... 120V, 50/60 Hz
Blade diameter ....................... 20" (50.8 cm)
Speeds .................................... 3 Intake, 3 Exhaust
Control .................................... Rotary Switch
Approvals ................................ UL Listed. Close mesh Fan guard
meets OSHA requirements.
20" WHOLE HOUSE WINDOW FAN
20" (50.8 cm) MODEL 3C614C/9166C
OPERATING INSTRUCTIONS & PARTS MANUAL
6. This Fan is intended for general use ONLY. It must NOT be used in
potentially dangerous locations such as flammable, explosive, chemi-
cal-laden or wet atmospheres.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT USE THIS FAN WITH ANY SOLID STATE SPEED CONTROL
DEVICE.
MAINTENANCE
WARNING: ALWAYS UNPLUG THE CORD BEFORE SERVICING.
CLEANING : Use a soft cloth and a mild soap solution such as liquid dish
washing detergent.
CAUTION: Do not use gasoline, benzine, thinner, harsh cleaners,
etc. which will damage the Fan.
Dry all parts with a soft cloth completely before reconnecting to power supply.
STORAGE : When not in use, keep unit in a clean dry place.
MOTOR IS PERMANENTLY LUBRICATED.
ASSEMBLY AND INSTALLATION
PLEASE REMOVE CORRUGATED PACKING RING BETWEEN FAN
BLADE AND GRILL BEFORE INSTALLATION AND OPERATION OF
FAN.
The large number of window styles and types makes it impossible to
describe one universal installation procedure.
The methods outlined below are recommended as being well-suited for
most common styles of double-hung windows. Whichever method you
choose should allow the window to be closed easily for security and
protection of home furnishings against the weather. Refer to illustrations
while following METHOD A
(OUTSIDE of TRIM) or METHOD B (INSIDE
of TRIM) below.
Tools Required: Screwdrivers
Hardware Provided: Four #8 x 3/4" Slotted Head Screws
METHOD A (OUTSIDE OF TRIM)
1. Loosen 4 Extender Panel Screws and extend Side Panels to clear the
outer edge of trim on each side of window. (Figure 1)
Rev. D 1/00 1 2085109A
GENERAL SAFETY INFORMATION
1. Make certain that the power source conforms to the electrical
requirements of the Fan.
2. The power cord is equipped with a three-prong grounded plug that
must be inserted into a matching receptacle. Under no circumstances
must the grounding prong be cut off the plug. Where a two-prong wall
receptacle is encountered, it must be replaced with a properly grounded
three-prong receptacle installed in accordance with the National
Electrical Code (NEC) and all applicable local codes and ordinances.
This work must be done only by a qualified electrician, using copper
wire only.
WARNING: USE OF A THREE-PRONG TO TWO-PRONG ADAPTER IS
NOT RECOMMENDED. IMPROPER CONNECTION MAY CREATE
THE RISK OF ELECTROCUTION. USE OF SUCH ADAPTERS IS NOT
PERMITTED IN CANADA.
3. Where possible, avoid the use of extension cords. If they must be
used, minimize the risk of overheating by ensuring that they are UL
listed and of the proper gage and length. Never use a single extension
cord to operate more than one Fan.
4. Do not insert fingers or foreign objects into the Fan. Do not block or
tamper with the Fan in any manner while it is in operation. Do not touch
the Fan while in operation or just after it has been turned off, as some
parts may be hot enough to cause injury.
5. Unplug power cord before installing or servicing the Fan.
WARNING: DO NOT DEPEND UPON THE ON-OFF SWITCH AS THE
SOLE MEANS OF DISCONNECTING POWER WHEN INSTALLING OR
SERVICING THE FAN. ALWAYS UNPLUG THE POWER CORD.
Figure 1
MODEL 3C614C/9166C
SPEED HIGH MED LOW
CFM 7005 6165 4160
M 3 /s 3.31 2.91 1.96
RPM 834 700 520
Amps 3.20 2.40 1.80
Watts 364 280 185
dB A 64 59 50
Slots
Flange
Extender
Panel
Screws
2. Rest Fan on window sill with Flange on Side Panels over trim. Push in
Side Panels tight against outer edge of trim. With Side Panel in position,
mark Screw locations at top of Slot and drive in the Wood Screws
(provided) until tight.
3. Retighten Extender Panel Screws to complete installation.
MODELO 3C614C/9166C
LISTA DE PIEZAS DE REPUESTO
No. Parte No. Descripción Cant.
Figura 3
1 2070024G Emblema AirKing 1
2 2010208 Protector del Ornamento 1
3 2096151 Rejilla Interior 1
4 2091121 Tornillo Prisionero 1
5 2011219 Hélice 1
6 2030073A Conjunto del Motor 1
7 3091118 Arandela #8 8
8 2091413 Tornillo para Madera #8 x 3/4" 4
9 2060085 Paneles Laterales 2
10 2090039 Tornillo #8 x 3/8" (Tipo 25) 4
11 2010720 Cuerpo del Ventilador con Canales 1
12 2011224 Rejilla Exterior 1
13 2090548 Atadura para Cable #10 1
14 3091135 Tornillo #10 x 1/2" 1
15 2090289 Capacitor 1
16 2011225 Cubierta del Motor 1
17 2090008 Tornillo #8 x 1/2" (Tipo 25) 5
18 3091815 Conector Eléctrico 4
MÉTODO B (POR ADENTRO DE LAS MOLDURAS)
1. Marque la posición de los
agujeros para los Tornillos en
los bordes interiores del marco
de la ventana utilizando el Patrón
suministrado.
(Figura 2)
2. Instale los 4 Tornillos en el
marco. NO LOS APRIETE DEL
TODO. Deje 1/8" (3,2 mm) entre
la superficie del marco y la
Cabeza de los Tornillos.
3. Afloje los 4 Tornillos para Paneles
de Extensión (Figura 1) y
extienda los Paneles Laterales
hasta que el Ventilador quede
bien ajustado entre los lados del
marco de la ventana.
4. Instale el Ventilador en la ventana
enganchando las Ranuras en los Tornillos
en el marco de la ventana. Deslice el
Ventilador hacia abajo en los Tornillos
hasta que descanse sobre la parte inferior
del marco.
(Figura 3)
5. Apriete los Tornillos para Paneles de
Extensión para asegurario en esa posición.
OPERACIÓN
Este Ventilador AirKing para Toda la Casa tiene un duradero motor
eléctrico reversible de 3 velocidades con arranque por capacitor. Tiene
tres velocidades: Alta (Hi), Media (Medium) y Baja (Low) tanto para uso
de Ventilador como de extactor. El interuptor de control está
convenientemente ubicado en la parte inferior derecha del cuerpo del
Ventilador. Ajuste la Perilla a la dirección y Velocidad deseadas.
Figura 2
Ranura
Tornillo
1/8" (3,2 mm)
No. Parte No. Descripción Cant.
PLANTILLA
Rev. D 1/00 4 2085109A
1
2
3
4
5
6
8 9
7
10
11
12
13
14
15
16
18
19
7
17
20
21
22
23
9
8
24
25
26
28
27
31
32
33
34
35
36
10
10
10
17
22
23
26
18 29
30
33
36
36
19 7092211 Tuerca Hexagonal #8 - 32 4
20 2010744 Cubierta del Interruptor 1
21 2055052 Interruptor Reversible de 3 Velocidades 1
22 2091133 Tuerca Hexagonal 1/4" - 20 4
23 2090053 Arandela de Presión 1/4" 4
24 2090566 Atadura para Cables 2
25 2090044 Tornillo 6 - 32 x 1/4" 1
26 2090509 Canal de Goma 4
27 3091303W Buje para el Alambre 1
28 2050009AW Cable de Alimentación 1
29 2046101 Alambre de Conducir Verde 1
30 2046922 Alambre de Conducir Azul 1
31 2084071 Plantilla 1
32 2065228A Placa del Interruptor 1
33 2091130 Tornillo 1/4" - 20 x 1" 4
34 2010745 Perilla del Interruptor 1
35 2090547 Tuerca de Lámina 3
36 2090062 Tornillo #8 x 1/2" (Punta A) 6