Audiovox Rampage ACD28 - Manual (Page 15)

Built into this radio are controls to operate an
optional CD changer. Please check with your
Rampage/Audiovox car stereo specialist for
recommendations of the models that will work
with this radio.
Once the changer is installed and properly
connected, it may be necessary to press the
RESET button behind the radio front panel to
initialize the complete installation.
Adjustment of the audio functions (volume, tone,
balance, and fader) for the CD changer operate
in the same manner as they do for radio play.
The following controls will operate the CD
changer when it is installed and connected to
this radio. Refer to the owner’s manual included
with the CD changer for instructions on the
installation and correct loading and use of the
CD magazine.
dq dq dq dq dq
CD CHANGER PAUSE/PLAY SELECTOR
( PAU )
During radio, or tape play, press the MODE
button
cu cu cu cu cu
to select operation of the CD changer
as shown by CDC on the display. Disc play will
begin, the disc and track number will be shown
on the display panel, and the center of the disc
icon ( ) will become animated. If a new
magazine has been loaded into the changer,
play will begin from the first track of the first disc
in the magazine. If a magazine was already in
the changer, play will resume from the track on
the disc previously in play.
During CD changer play, pressing the
PAU
button once will stop changer play; PAUSE will
appear on the display and the center of the disc
icon will remain stationary. To resume disc
play, press the
PAU button again and disc play
will resume from the point at which it was
interrupted.
dr dr dr dr dr
DISC SELECT ( UP/DN)
These buttons are used to select the desired
disc for play. To advance to a higher number
CD CHCD CHCD CHCD CHCD CH
AAAAA
NGER CONTRNGER CONTRNGER CONTRNGER CONTRNGER CONTR
OLOLOLOLOL
SSSSS
15 15 15 15 15
CD CH CD CH CD CH CD CH CD CHA A A A ANGER CONTR NGER CONTR NGER CONTR NGER CONTR NGER CONTROL OL OL OL OLS S S S S
disc, press the UP button To return to a lower
number disc, press the DN button . The
number of the disc in play will be shown on the
display panel.
ds ds ds ds ds
TRACK SELECT ( / )
This button is used to quickly select the
beginning of a particular track. With each
momentary press of the Forward Track Select
button (
), the next higher track number will
be selected as shown on the display panel.
Similarly, with each momentary press of the
Backward Track Select button (
), the next
lower track number will be selected.
dt dt dt dt dt
FOWARD/REVERSE SEARCH (CUE/
REVIEW)
High-speed audible search to any forward or
reverse section of the disc can be made with
this feature. Press and hold the forward (cue)
button (
) to advance rapidly in the forward
direction, or press and hold the reverse (review)
button (
) to advance rapidly in the reverse
(backward) direction. In either case, the center
of the disc icon will rotate faster when search
is active.
du du du du du
TRACK SCAN SELECTOR ( SCN)
When the SCN button is momentarily pressed,
the SCN indication will appear on the display
panel, and the first 10 seconds of each track
on the disc will be played in order. When a
desired track is reached, press the
SCN button
again and play of the selected track will
continue (SCN will disappear from the display
panel). The Track Scan mode will also be
canceled by activating any other disc function
(Track Select, Repeat or Random).
When the
SCN button is pressed and held for
more than 2 seconds, the disc scan mode is
activated; DSN will appear on the display and
the first 10 seconds of the first track on each
disc will be played in disc order. This mode is
canceled in the same manner as before.