LG LB-H368GSS0 - Manual (Page 6)

6
A/CL
7
10
11
9
2
8
5
6
4
1
3
Optional Function
• WIRELESS REMOTE CONTROLLER
This air-conditioner is equipped with wired remote controller basically. But if you want to have the wireless
remote controller, you pay for it.
Remote Controller
Signal transmitter
Transmits the signals to the signal receptor.
FAN Operation Button
Used to circulate room air without cooling or heating.
Cooling Operation Button
Soft Dry Operation Button
Used to dehumidify without overcooling.
Heating Operation Button
(Heat pump model only)
Timer Set Button
Used to set the timer when the desired time is
obtained.
Then the wired remote controller is set up to 24 hours
by an hour but the wireless remote controller is set up
to 7 hours by an hour. Therefore, if you want to set
over 7 hours, use the wired remote controller.
Fan Speed Button
Used to set the desired fan speed.
On/Off Button
Operation starts when this button is pressed, and stops
when the button is pressed again.
Set Temperature Button
Used to set the temperature when the desired
temperature is obtained
Auto Operation Button
Plasma Air Clean Button(Optional)
Electric Heater Button(Optional: 48/60k ZL/ZA/ZP Model only)
Used to set the Electric Heater.
11
10
9
8
7
6
5
4
3
2
1
CAUTION
for handling the Remote Controller
• Aim at the signal receptor on the wired remote controller so as to operate.
• The remote control signal can be received at a distance of up to about 7m.
• Be sure that there are no obstructions between the remote controller and the signal receptor.
• Do not drop or throw the remote controller.
• Do not place the remote controller in a location exposed to direct sunlight, or near the heating unit, or any
other heat source.
• Block a strong light over the signal receptor with a curtain or etc. so as to prevent the abnormal operation.
(ex:electronic quick start, ELBA, inverter type fluorescent lamp)