LG V-C4B43NT - Manual (Page 5)

Please read all the following information,
which contains important instructions for the
safety, the use and the maintenance of the
appliance.
This appliance complies with the following EC
Directives: -73/23/EEC, 93/68/EEC-Low
Voltage Directive-89/336EEC -EMC Directive.
■ The appliance is not intended for use by
young children or infirm persons without
supervision. Young children should be
supervised to ensure that they do not play
with the appliance.
■ Do not use the appliance If the mains lead
is damaged or faulty.
■ If the mains lead is damaged, it must be
replaced by an approved LG Electronics
Service Agent in order to avoid a hazard.
■ Always switch the vaccum cleaner off
before :
• changing the dust bag
• changing or cleaning the filters.
■ If no dustbag is inserted, the cover
cannot be closed. Please do not use
force!
■ Do not vacuum flammable or explosive
substances (liquids or gases).
■ Do not vacuum hot ash, embers etc. nor
sharp obiects.
■ Do not vacuum water or other liquids.
■ When you vacuum with an attachment
appliance that has a rotating brush roller:
• do not reach into the running brush
roller.
WARNING! Should it become necessary to
replace the moulded on plug then the
detective plug should be destroyed to avoid
any possible shock hazard that could occur
should such a plug be inserted into a 13 amp
socket else where in the house.
Connecting the flexible hose
Push the end of the head (1) on the flexible hose
(2) into the attachment point on the vacuum cleaner.
To remove the flexible hose from the vacuum
cleaner, press on the button (3) situated on the
head, then pull upwards.
Assembling the tubes
(depending on model)
• Metal tube (4,5)
- Fit together the two tubes by twisting slightly.
• Telescopic tube (6)
- Push spring latch (7).
- Pull out tube to required length.
- Release spring latch to lock.
Using the cleaning head and Accessory
Nozzles
(depending on model)
Fit the large cleaning head onto the end of the tube.
• The 2 position head (10) is equipped with
a pedal (11) which allows you to alter its
position according to the type of floor to be
cleaned. Hard floor position (tiles, parquet
floors...): Press on the pedal to lower the
brush.Carpet or rug position: Press on
the pedal to lift the brush up.
• Turbine brush nozzle (31)
- Air adjustment (32)
Slide the air control lever to the right for
long pile carpet and to the left for short
pile carpet.
- Cleaning turbine brush nozzle (33)
Press the button on the rear side of the
nozzle to separate the air cover.
Use the dusting brush &crevice tool to
vacuum clean the brush and fan.
• Crevice Tool (14)
For vacuuming in those normally inaccess-
ible places i.e. reaching cobwebs, or down
the side of a sofa!
• Upholstery Nozzle (15)
For vacuuming upholstery, mattresses, etc. The
thread collectors help to pick up the threads and fluff.
• Dusting brush (16)
For vacuuming picture frames furniture
outlines, books and other uneven objects.
• Accessory Holder can be attached on the
Extention wands using clamping hook.
Accessories can be stored in the holder (30).
- 4 -
E
Information for your safety How to Use