Avanti IMR28SS User Manual

Page 7

IMPORTANT SAFETY INSTRUCTIONS

aWARNINGa

TO REDUCE THE RISK OF FIRE,
ELECTRICAL SHOCK, OR INJURY WHEN
USING YOUR APPLIANCE, FOLLOW THESE
BASIC PRECAUTIONS:

• READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE.

• DANGER OR WARNING: RISK OF CHILD ENTRAPMENT.

CHILD ENTRAPMENT AND SUFFOCATION ARE NOT PROBLEMS OF THE PAST.
JUNKED OR ABANDONED APPLIANCES ARE STILL DANGEROUS. . . EVEN IF THEY
WILL “JUST SIT IN THE GARAGE A FEW DAYS.”

• BEFORE YOU THROW AWAY YOUR APPLIANCE: REMOVE THE DOORS. LEAVE THE

SHELVES IN PLACE SO THAT CHILDREN MAY NOT EASILY CLIMB INSIDE.

• NEVER ALLOW CHILDREN TO OPERATE, PLAY WITH, OR CRAWL INSIDE THE

APPLIANCE.

• NEVER CLEAN APPLIANCE PARTS WITH FLAMMABLE FLUIDS. THE FUMES CAN

CREATE A FIRE HAZARD OR EXPLOSION.

• DO NOT STORE OR USE GASOLINE OR ANY OTHER FLAMMABLE VAPORS AND

LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. THE FUMES CAN
CREATE A FIRE HAZARD OR EXPLOSION.

-SAVE THESE INSTRUCTIONS-

INSTALLATION INSTRUCTIONS

BEFORE USING YOUR APPLIANCE
• Remove the exterior and interior packing.
• Check to be sure you have all of the following parts:

• 1 ice box
• 2 door bins
• 2 crisper drawers
• 2 glass shelves
• 1

plastic

scoop

• 25 feet hose
• 1 glass crisper lid
• 1 instruction manual
• 1 door handle assembly

• Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.

This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.

• Clean the interior surface with lukewarm water using a soft cloth.

INSTALLATION OF YOUR APPLIANCE
• This appliance is designed to be recessed or built-in (fully recessed).

• Place your appliance on a floor that is strong enough to support the appliance when it is fully

loaded. Remember that the unit will be significantly heavier once it is fully loaded. To level your
appliance, adjust the legs at the front of the appliance.

• Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).

Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the appliance not to perform
properly.

• Avoid locating the appliance in moist areas. Too much moisture in the air will cause frost to form

quickly on the evaporator requiring more frequent defrosting of the appliance.

• Plug the appliance into an exclusive properly-installed and grounded wall outlet. Do not under any