LG LWP-273W - Manual (Page 2)

2
IMPORTANT: Read and follow these instructions.
Safety is foremost---both your own and that of other
people. Many important safety instructions are provided
in this instruction and your appliance. Always read and
observe all safety instructions.
1 Remove pedestal, installation hardware, and
instructions from the shipping carton.
2 Position the washer/combo/dryer on top of the pedestal.
NOTE: Because of the weight of the washer/combo,
two or more people may be needed.
installed, unplug it, disconnect the inlet
NOTE: If the washer or combo was previously
hose (s) from the faucet (s), disconnect
the drain hose, and drain all hoses.
4 Remove the paper from the
bracket.
5 Attach the double-faced tape of the bracket to the
washer/combo/dryer as shown so the bent parts of the
brackets align with the edge and can be attached
to the pedestal with screws.
NOTE: Attach the lower side first.
6 Be sure to press the adhesive parts of the brackets
firmly to the appliance.
7 Install the eight (8) screws (supplied) to attach the
brackets to the pedestal.
8 Move the washer/combo /dryer to the desired place.
NOTE: The appliance and pedestal assembly
must be placed on a solid and level floor
for proper operation. Adjust the legs of
the appliance and pedestal by turning
with a wrench. Then, adjust the lock nut
toward the pedestal while holding the
pedestal leg using a wrench.
The installer must have electrical and mechanical training and acceptable knowledge in the
required work.
Excessive Weight Hazard
Two or more people may be needed to install and move the
appliance and pedestal assembly. Do not allow children to play
on the drawer. Do not step on the handle.
NOTICE
W
WASHER/COMBO/DRYER INSTALLATION
ARNING
A. Uninstalling an electric dryer:
1) Unplug the power supply cord,
2) Pull the dryer away from the wall enough to loosen the vent clamp.
Loosen the clamp and carefully remove the exhaust vent from the
dryer exhaust outlet.
B. Uninstalling a gas dryer:
1) Unplug power supply cord.
2) Turn of f the gas supply
3) Pull the dryer away from the wall enough to loosen the vent clamp.
Loosen the clamp and carefully remove the exhaust vent from the
dryer exhaust outlet.
NOTE: If dryer was previously installed, uninstall it as follows:
3
Level the washer/combo/dryer on the
pedestal by adjusting the feet.
Lock nut
Adjustable
feet
Adjustable
feet
Lock nut
Adjustable
feet
Adjustable
feet
For washer/
combo
For dryer
For dryer
For washer/
combo
ENGLISH