Subscribing handset to base station – Audiovox 4GHz User Manual
Page 11
E - 10
SUBSCRIBING HANDSET TO BASE STATION
DELETING A BASE STATION
If the user wants to remove the entry for the base station from the handset’s memory, this
process can be undertaken whether or not the handset is within range of the base station
concerned.
• Press scroll keys
5/6(6) to select “ADVANCED”, then press
*
to confirm.
• Press scroll keys
5/6(6) again to select “DELETE”, then press YES (3) to confirm.
• Enter the PIN code then press YES (3) to confirm
• Press scroll keys
5/6(6) to select a base ID number that to be deleted, then press YES
(3) to confirm.
• Handset will show “PLEASE WAIT” then “SEARCHING. . . “ is displayed.
SUBSCRIBING HANDSET TO TL1102 BASE STATIONS
This is the case when the user wishes to add a subscription to a base station.
• Press and hold the PAGE button on the new station, (about 6 seconds), until the LED flashes
and release the PAGE button after stops (flashing). This will put the base into subscription
mode for about 5 minutes.
• Press scroll keys
5/6(6) to select “ADVANCED”, then press
*
to confirm.
• Press scroll keys
5/6(6) again to select “REGISTER”, press YES (3) to confirm.
• Enter the PIN code “4321” then press YES (3) to confirm
• Press scroll keys
5/6(6) to select a new base ID number for new base station.
• Press YES (3) to confirm the base number, then handset will start the subscription and
“SEARCHING. . . “ is displayed.
• “REGISTERED x” will be displayed for a few seconds and then “H x” be shown on LCD if
the subscription is successful. Else, “H ?” will be shown for fail subscription.
Remark : Please note that one base station can register up to 4 handsets.
Please note that subscription of the additional handset to a base station is required before
first use.
Subscriptions requires the use of a PIN code. The PIN code is 4321.
Important : For best result, the handset set up procedure should be performed within 5 feet
of the main base.
9038_1_ib_e.p65
10/31/03, 12:13 PM
10