Avanti BCAD680 - Manual (Page 11)

11
?
When removing any of these shelves out of the rail compartment, you must first disassemble and
remove both of the plastic posts after removing the Phillips screws that holds each post in place.
See figure "AA"
FIG "AA"
CARE AND MAINTENANCE
? Replacing Your Fluorescent Light
NOTE:
All parts removed must be saved to do the replacement of the fluorescent light.
Before removing the fluorescent light, either turn off the appliance or disconnect the electricity
leading into the appliance at the main power supply. Failur e to do so could result in electrical
shock or personal injury.
?
Turn off the fluorescent light switch .
?
Pull down to remove the fluorescent light cover (3) softly.
?
Rotate the fluorescent light (2) 90° and pull down softly to remove it from the light holder (1).
?
Replace with a T-5 fluorescent light that is the same shape and size.
?
Replace the light cover (3).
1. Light Holder
2. Fluorescent Light T5 (8 W atts)
3. Light Cover
? Cleaning Your Beverage Center
?
Unplug the appliance, and remove all item s including shelves.
?
Wash the inside surfaces with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.