Avanti CF100 - Manual (Page 7)

7
IMPORTANT SAFEGUARDS
Before the wine chiller is used, it must be properly positioned and installed as
described in this manual, so read the manual carefully. To reduce the risk of fire,
electrical shock or injury when using the wine chiller, follow basic precautions,
including the following:
• Plug into a grounded 3-prong outlet, do not remove grounding prong, do not use an adapter, and do
not use an extension cord
• Replace all panels before operating
• It is recommended that a separate circuit, serving only your wine chiller, be provided. Use
receptacles that cannot be turned off by a switch or pull chain
• Never clean wine chiller parts with flammable fluids. These fumes can create a fire hazard or
explosion. And do not store or use gasoline or other flammable vapors and liquids in the vicinity of
this or any other appliance. The fumes can create a fire hazard or explosion.
• Before proceeding with cleaning and maintenance operations, make sure the power line of the unit
is disconnected.
• Do not connect or disconnect the electric plug when your hands are wet
• Unplug the wine chiller or disconnect the power before cleaning or servicing. Failure to do so can
result in electrical shock or death.
• Do not attempt to repair or replace any part of your wine chiller unless it is specifically recommended
in this material. All other servicing should be referred to a qualified technician.
• Use two or more people to move and install the wine chiller. Failure to do so can result in back or
other injury.
• To ensure proper ventilation for your wine chiller, the front of the unit must be completely
unobstructed. Choose a well-ventilated area with temperatures above 55 0 F (13 0 C) and below 90 0 F
(32 0 C). This unit must be installed in an area protected from the elements, such as wind, rain,
water spray or sunlight.
• The wine chiller should not be located next to ovens, grills or other sources of high heat.
• The wine chiller must be installed with all electrical, water and drain connections in accordance with
state and local codes. A standard electrical supply (115 V AC only, 60 Hz), properly grounded in
accordance with the National Electrical Code and local codes and ordinances is required.
• Do not kink or pinch the power supply cord of the wine chiller.
• The fuse (or circuit breaker) size should be 15 amperes.
• It is important for the wine chiller to be leveled in order to work properly. You may need to make
several adjustments to level it.
• All installation must be in accordance with local plumbing code requirements.
• Make certain that the pipes are not pinched or kinked or damaged during installation.
• Check for leaks after connection.
• Never allow children to operate, play with or crawl inside the wine chiller
• Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may damage
or discolor the interior.
• Do not use this apparatus for other than its intended purpose.