LG WM8000HWA - Manual (Page 27)

27 USING YOUR WASHING MACHINE
ENGLISH Presetting the start time, DELAY WASH
You can set the desired start time.
1 Press A and turn
B
to the desired cycle.
2 Press the desired option to use the other options.
3 Press repeatedly to select the desired start time.
- light will turn on.
- The set start time appears on the display panel.
- Each press of the button increases the delay time by
one hour, up to 19 hours.
4 Press C .
Efficiency cleaning, STEAM
Adding the Steam option to these cycles provides superior
cleaning performance.
By using a hot steam spray from above and cooler water
below, fabrics get the cleaning benefits of a super hot wash,
without the energy usage or potential damage to fabrics.
1 Press A and turn
B
to the desired cycle.
2 Press . The washer will automatically adjust the
cycle settings.
3 Set any other desired options.
4 Press C .
WARNING
y Do not touch the door during steam cycles. The door
surface can become very hot. Allow the door lock to
release before opening the door.
y Do not attempt to override the door lock mechanism
or reach into the washer during a steam cycle. Steam
can cause severe burns.
NOTE
y The steam option cannot be used with all cycles.
y Steam may not be clearly visible during the steam
cycles. This is normal. Too much steam could damage
clothing.
y Do not use steam with delicate fabrics such as wool,
silk, or easily discolored fabrics.
Saving energy, COLDWASH™
Adding the COLDWASH™ option reduces energy usage and
provides the same washing performance as a warm water
wash.
By using 6 different washing motion (Tumbling, Rolling,
Stepping, Scrubbing, Swing, Filtration), fabrics get the
cleaning benefits, without the energy usage.
1 Press A and turn
B
to the desired cycle.
2 Press
. The washer will automatically adjust the
cycle settings.
3 Set any other desired options.
4 Press C .
NOTE
y When you select the COLDWASH™ option, wash time
will be increased up to 10 minutes.
y For high wash efficiency, it is recommended to use less
than 8 pounds.
Saving time, TURBOWASH™
Adding the Turbo Wash option reduces cycle time and
provides good performance in normal cycle.
By using the Twin Spray and the Optimization, We can save
the time without sacrificing performance.
1 Press A and turn
B
to the desired cycle.
2 Press
. The washer will automatically adjust the
cycle settings.
3 Set any other desired options.
4 Press C .
NOTE
y The Turbo Wash option cannot be used with all cycles.
y Turbo Wash is available in the beginning of the Cotton/
Normal and Perm. Press cycles.
y Press and hold the Turbo Wash button to change the
default settings.