LG LFC24770ST - Manual (Page 13)

13 INSTALLATION
Removing/Assembling the
Freezer Drawer Handle
Removing the Handle
1 Loosen the set screws located on the
lower side of the handle with a 3/32 in. (2.5mm)
Allen wrench and remove the handle.
2 Loosen the mounting fasteners that
connect to the
freezer drawer
and handle
using a
(6.35 mm)
1 /
4
in.
Allen wrench,
and remove
the mounting
fasteners.
Assembling the Handle
1 Assemble the mounting fasteners at
both ends of the handle using a 1 /
4
in. Allen
(6.35 mm) wrench.
2 Place the handle on the door by fitting the
handle
footprints over
the mounting
fasteners and
tightening the
set screws
with a 3/32 in.
(2.5 mm)
Allen wrench.
Removing/Assembling the
Doors and Drawers
When it is necessary to move the refrigerator
through a narrow opening, removing the doors
is the recommended procedure.
WARNING
When assembling or disassembling the
handle:
 Grasp the handle tightly to avoid drop-
ping it.
 Do not swing the handle into nearby
people or animals.
 Make sure that the bracket hole of the
handle fits properly into the stopper
bolt of the door. Assemble the set
screws to fix the handle into place.
 Make sure that there is not a gap
between the door and handle after
assembling the handle.
WARNING
 If your entrance door is too narrow
for the refrigerator to pass through,
remove the refrigerator doors and move
the refrigerator sid eways through the
doorway.
 Use two or more people to remove and
install the refrigerator doors. Failure to
do so can result in back or other injury.
 Disconnect the electrical supply to the
refrigerator before installation. Failure
to do so could result in serious injury or
death.
 Do not put hands, feet or other objects
into the air vents or bottom of the
refrigerator. You may be injured or
receive an electrical shock.
 Be careful when handling the hinge and
stopper. You may be injured.
 Remove food and bins before detaching
the doors and drawers.
ENGLISH