I n s ta l l at i o n – LG wm2455hw User Manual

Page 7

I N S TA L L AT I O N

CONNECTING THE WATER LINES

CONNECTING THE DRAIN LINE

Insert the end of the drain hose into the floor

drain. Secure the hose in place to prevent it

from moving.

Drain Hose

Floor Drain

Option 3: Floor Drain

Stand

Pipe

Tie Strap

Clip the end of the hose into the elbow bracket.

Insert the end of the drain hose into a standpipe.

Use tie strap to secure the drain hose in place.
NOTE: Total height of the hose end should not

exceed 96 in. (244.8 cm) from the bottom of the

washer.

Option 1: Standpipe

Elbow

Bracket

Drain

Hose

Clip the end of the hose into the elbow bracket.

Hang the end of the drain hose over the side of

the laundry tub. Use tie strap to secure the drain

hose in place.
NOTE: Total height of the hose end should not

exceed 96 in. (244.8 cm) from the bottom of the

washer.

Laundry

Tub

Option 2: Laundry Tub

Elbow

Bracket

Tie

Strap

Drain

Hose

Insert a rubber seal into the threaded

fittings on each hose.

Rubber Seal

Water Hose

(to tap)

Rubber Seal

Water Hose

(to water inlet

on washer)

Attach the hot water line to the hot water

tap. Attach the cold water line to the cold

water tap.

Tighten the fittings securely. Open the water

taps fully to check for leaks.

Water Tap

NOTE: Do not cross-thread the hose fittings.
Attach the hot water line to the red hot water

inlet on the back of the washer. Attach the

cold water line to the blue cold water inlet on

the back of the washer. Tighten the fittings

securely.

Water

Inlets

•

IMPORTANT: Use new hoses when installing

the washer. Do NOT reuse old hoses.

•

IMPORTANT: Use ONLY the inlet hoses

provided by LG with this laundry product.

Aftermarket hoses are not guaranteed to fit or

function correctly. Other hoses may not tighten

correctly and could cause leaks. Subsequent

damage to product or property will not be

covered under the terms of LG's warranty.

• Water supply pressure must be between

14.5 PSI and 116 PSI (100~800 kPa). If the

water supply pressure is more than 116 PSI, a

pressure reducing valve must be installed.

• Periodically check the hose for cracks, leaks,

and wear, and replace the hose if necessary.

• Make sure that the water lines are not stretched,

pinched, crushed, or kinked.

• The washer should never be installed or stored

in a location subject to freezing temperatures.

Damage to the water lines and internal

mechanisms of the washer can result. If the

washer was exposed to freezing temperatures

prior to installation, allow it to stand at room

temperature for several hours before use.

• The drain hose should always be properly

secured. Failure to properly secure the drain

hose can result in flooding and property

damage.

• Do not install the end of the drain hose higher

than 96 in. (244.8 cm) above the bottom of the

washer.

• The drain must be installed in accordance with

any applicable local codes and regulations.

• Make sure that the water lines are not stretched,

pinched, crushed, or kinked.

MFL31245113_ENG.indd 12-13

2007.10.4 2:31:34 PM