LG LUV400T - Manual (Page 20)

20
CARE & CLEANING
5. Fit the agitator through the belt, making sure the
belt is aligned with the pulley section of the
agitator.
6. Lower the agitator into place, making sure the
oval shaped tabs fit into the indents on the head.
7. Reinstall the agitator brush cover as described
above.
For a replacement belt, order LG service center belt
part # MAS61842501.
Replacing the batteries
1. Slide the battery cover up and away from the
hose.
2. Replace the two batteries and reinstall the
battery cover.
NOTE : Replacing isn’t done yet, use the power
button on the body.
Removing Clogs
If you notice a loss in suction, first check the filters
as described on pages 18. If the filters are clean,
there may be a clog. The arrows show areas where
clogs are most likely to occur.
To check for clogs:
1. Check the hose where it connects to the handle
by pressing the two release buttons on the top
end of the hose.
2. Release the wand from the vacuum cleaner by
pressing the wand release button.
Separate each accessories, see page 8. and
check accessories.
3. Remove the dust tank and check the dust tank
inlet and body inlet where it connects to the
vacuum cleaner body.
Electrical shock and personal injury hazard.
Always unplug the vacuum cleaner before
servicing. Failure to do so could result in
electrical shock or personal injury.
WARNING
➀
➁