beautypg.com

Installation test (duct) – LG DLGX4071V User Manual

Page 29

background image

29

ENGLISH

InstallatIon InstrUCtIons

InstallatIon InstrUCtIons

Installation test (Duct)

Once you have completed the installation of the dryer, use this

test to make sure the condition of the exhaust system is adequate

for proper operation of the dryer. This test should be performed

to alert you to any serious problems in the exhaust system of your

home.

• Your dryer features FLOW SENSE

TM

, an innovative sensing system

that automatically detects blockages and restrictions in dryer

ductwork. Keeping ductwork clean of lint buildup and free of

restrictions allows clothes to dry faster and reduces energy use.

The dryer should be cool before starting this test. If the dryer was

warmed up during installation, run the AIR DRY cycle for a few

minutes to reduce the interior temperature.

To activate the Installation test:

1. Remove the drying rack and literature, and then close the

door.

Do not load anything in the drum for this test, as in may affect

the accuracy of the results.

2. Press and hold the SIGNAL ON/OFF and TEMP. CONTROL

buttons and then press the POWER button.

This button sequence activates the installation test. The code

will display if the activation is successful.

3. Press START/PAUSE button.

The dryer will start the test, which will last about two minutes.

The heat will be turned on and the temperatures in the drum

will be measured.


4. Check the display for results.

During the two minute test cycle, monitor the FLOW SENSE

TM

display on the control panel. If no bars are displayed, when

the cycle ends, the exhaust system is adequate. If the exhaust

system is severely restricted, the display will show four bars.

Other problems may also be shown with error codes. Refer to

the next page for error code details and solutions.

Four bars indicates that the exhaust system is severely restricted.

Have the system checked immediately, as performance will be

poor.

5. END of Cycle.

At the end of the test cycle, will display. The test cycle

will end and the dryer will shut off automatically after a short

delay.

NO BARS:

OK

FOUR BARS:

RESTRICTED

notE

MFL62512888_en_120828.indd 29

2012.8.28 3:20:40 PM

This manual is related to the following products: