Amana W10233410A - Manual (Page 23)

23
To use the drying rack
Do not remove the lint screen.
1. Open dryer door.
A
A. Front edge
2. Place drying rack inside dryer drum, positioning the back wire
on the ledge of the inner dryer back panel. Push down on
front edge of drying rack to secure over the lint screen.
A
B
A. Drying rack front edge
B. Dryer back panel
3. Put the wet items on top of the drying rack. Leave space
between the items so air can reach all the surfaces.
NOTE: Do not allow items to hang over the edge of the drying
rack.
4. Close the door.
5. Press the POWER button.
6. Select a timed cycle and temperature (see following chart).
Items containing foam, rubber, or plastic must be dried on a
clothesline or by using the Air Dry temperature setting.
7. You may change the cycle time by pressing MORE TIME or
LESS TIME. Reset time as needed to complete drying. Refer
to the following table.
8. Press (and hold) START button (about 3 seconds).
NOTE: You must remove drying rack for normal tumbling. Do not
use auto cycles with the drying rack.
This chart shows examples of items that can be rack dried and
the suggested temperature setting and drying time. Actual drying
time will depend on the amount of moisture items hold.
Rack Dry Setting Temp. Time*
Wool Sweaters
Block to shape and lay flat on
the drying rack.
Timed
cycles Low 60
Stuffed toys or pillows
Cotton or polyester fiber filled
Timed
cycles Low 60
Stuffed toys or pillows
Foam rubber filled
Timed
cycles Air Dry
(no heat)
90
Sneakers or canvas shoes Timed
cycles Air Dry
(no heat)
90
*(Minutes) Reset time to complete drying, if needed.