Audiovox BP210 - Manual (Page 3)

Wiring Your BP Speaker Box
The lighting elements of your Jensen products provide you with a unique custom touch to your
vehicle. Jensen’s Red and Blue-Hue illumination allows great creative oppor tunities for the beginner
and seasoned custom installer alike. The interior of your vehicle will never sound or look ordinar y
again. Let your imagination take you there.
The lighting features of all Jensen products require a 12 volt power source to operate. The polarity
(+ and -) indicators for each set of inputs also appear on terminal cup.
Notice: There are no removable or ser viceable par ts on
the speaker. Tampering with the speaker or any of it's
components will damage the speaker and void the
warranty.
Connect the positive (+) wire from amplifier output to
the positive terminal (red) on enclosure.
Connect the negative (-) wire from amplifier output to
the negative terminal (black) on enclosure.
– +
12 Volt DC
Input
Chassis
Ground
Lighting Hook-Up From Rear
12 volt switched
+ DC source
+
+ -
Jensen Lighting
Input Terminals
NOTE: Must use 12 volt switched output ONLY.
Head Unit
1.
Do not connect amplifier or any audio source to Jensen-
lighting inputs. Inputs are designed for switched 12-Volt DC
power source only. Do not connect your Jensen product
directly to your batter y permanently, as it will cause your
batter y to discharge. Please use a switched 12 volt source.
See fig. 1, (illustrates wiring diagram) be sure to maintain
polarity. Be sure to connect to a constant switched 12 volt
source. Correct connection would be the switched positive
(+) 12 volt wire to the Positive (+) lighting input terminal
and connect the negative (- ) lighting input terminal to a
good chassis ground or negative (- ) ground wire.
Red/Blue
Lighting Switch
Wiring Your Bandpass Speaker System