Electrolux EDC 503 M - Manual (Page 25)

25
ENGLISH
Important information regarding
installation
■
Hot air emitted by the appliance may reach
temperatures of up to 60°C. Therefore, do not
place appliance on floors which are not resistant to
high temperatures.
■
Make sure that the temperature of the room in
which the appliance is installed does not exceed
35°C. Excessive room temperature will prolong
drying times and cause energy consumption to
increase.
■
Please keep space surrounding tumble dryer as
clean as possible.
■
Do not remove the appliance’s adjustable feet. It is
essential to provide a certain amount of space
between the floor and the appliance for ventilation
purposes. Blocking ventilation would inevitably
cause the appliance’s inside temperature to
increase and would therefore affect the appliance’s
efficiency.
Electrical connections
The tumble dryer comes with cable and plug for 230V
single phase 10 A connections. Permanent installation
of the appliance in humid environments, such as
bathrooms, must be carried out in full compliance
with the relevant laws and regulations. Permanent
electrical connections must be carried out by qualified
personnel only.
Stacking Kit (optional accessory)
This tumble dryer may be stacked on a front-loading
washing machine. However, the tumble dryer will
have to be fixed to the washing machine. For this to be
carried out, the special stacking kit (available from all
Zanussi Authorised Dealers) will be required.
Connecting a drain hose
If there is a sink or drain near the appliance, the
condensed water can be discharged directly through a
hose that is available on the market.
In order to connect the hose to the appliance proceed
as follows:
■ Remove the clamp (A)
■ Pull out the plug (B)
■ Insert the drain hose (C)
■ Fasten the hose (C) to the appliance using the
clamp (A).
If the appliance is stacked on the washing machine,
the condensed water can be discharged through the
hose as shown in figure, but take into account that the
hose must be pointed downwards.
P1046
C
P1043
A
B
A
B C
P1044