LG MT12AH - Manual (Page 16)

16 Multi-Type Air Conditioner
HI
ZONE
Operation unit Program set
Room Temp
MED
LO JET
Heater
Defrost
Filter Preheat
Humidify
Out door
Time
Timer
On
Set no. Time Off
01 03 05 07 09 11 13 15 17 19 21 23
1 2 3 4
AUTO SWING OPERATION FAN SPEED SUB FUNCTION SET TEMP
AUTO
COOLING MODEL
Cooling Operation Soft Dry Operation Auto Operation
ZONE
Operation unit Program set
Room Temp
MED
LO
AUTO
JET Heater
Defrost
Filter Preheat
Humidify
Out door
Time
Timer
On
Set no. Time Off
01 03 05 07 09 11 13 15 17 19 21 23
1 2 3 4
AUTO SWING OPERATION FAN SPEED SUB FUNCTION SET TEMP
HI HI
ZONE
Operation unit Program set
Room Temp
MED
AUTO
JET Heater
Defrost
Filter Preheat
Humidify
Out door
Time
Timer
On
Set no. Time Off
01 03 05 07 09 11 13 15 17 19 21 23
1 2 3 4
AUTO SWING OPERATION FAN SPEED SUB FUNCTION SET TEMP
LO
HI
LO
ZONE
Operation unit Program set
Room Temp
MED JET
Heater
Defrost
Filter Preheat
Humidify
Out door
Time
Timer
On
Set no. Time Off
01 03 05 07 09 11 13 15 17 19 21 23
1 2 3 4
AUTO SWING OPERATION FAN SPEED SUB FUNCTION SET TEMP
AUTO
Operation Display
To raise the Temperature.
To lower the Temperature.
Cold Cool Proper Warm Hot
Operating Instructions
Auto Operation Mode (Cooling model)
1 Press the On/Off Button.
2 To select Auto Operation, press the Operation Mode Selection button.
Each time the button is pressed, the operation mode is shifted in the direction of the arrow.
During Auto Operation:
o You cannot switch the indoor fan speed. It has already been set by the Fuzzy rule.
o If the system is not operating as desired, manually switch to another mode. The system will not
automatically switch from the cooling mode to the heating mode, or from heating to cooling, it must be
done by manually resetting.
o During Auto Operation, pressing the chaos swing button makes the horizontal louvers swing up and
down automatically. If you want to stop auto-swing, press the chaos swing button again.
3 The temperature and fan speed are automatically set by the electronic controls based on the actual
room temperature. If you want to change the set temperature, close the door on the remote control
and press the Room Temperature Setting buttons. The cooler or warmer you feel, the more times
(up to two times) you should press the button. The set temperature will then be changed.
The temperature can be set within a range of -2~2 by 1 level.
(This indication will be shifted to the initial
Auto Mode Display state after 5 seconds.)