Connecting network devices – Asus GigaX1108 User Manual
Page 5
ASUS GigaX1105/GigaX1108
1-5
English
Connecting network devices
Follow these instructions to connect network devices to the GigaX1105 or
GigaX1108 switch.
1. Connect one end of the Ethernet cable to the Ethernet port on the rear
panel of the switch. Connect the other end to the Ethernet port on the
other network device. Repeat this step for additional network devices.
2. Plug one end of the AC power cord to the power connector on the switch
rear panel, then plug the other end to an electrical outlet.
3. The Power LED and LED indicators for active Ethernet ports light up
indicating that the device is turned on and in use. Refer to the front panel
table for LED indications.
NOTES
•
Use Category 5 Ethernet cables, not exceeding 100 meters (328
feet), otherwise, there will be connection problems or a decrease in
data transfer speeds.
•
The Ethernet ports on the switch may be used as uplinks to other
switches, hubs, bridges, or repeaters. The switch is capable of
detecting and adjusting either crossover or straight-through cables.
GigaX1108 Connection Example