AT&T TL 74208 - Manual (Page 9)

Getting started
Battery installation & charging
Install the battery as shown below. After installing the battery,
you can make and receive short calls, but replace the handset
in the charger when not in use. For optimal performance, charge
the handset battery for at least 16 hours before use. When fully
charged, the handset battery provides approximately five hours
of talk time or three days of standby time.
If the battery is depleted, it may take approximately four minutes
to charge the handset before it can resume screen display. The
screen will continue to display
LOW BATTERY until the battery
has charged for approximately one hour.
THIS SIDE UP
W
ARNING:DO NO
T BURN OR
PUNCTURE BA
TTERIES
MADE IN CHIN
A
Battery Pack BT5633/BT682
3
3.6V 550mAh Ni-MH
THIS SIDE UP
W
A
RNING:DO NOT
BURN OR
PUNCTURE BA
TTERIES
MADE IN CHINA Battery Pac
k
BT5633/BT6823 3.6V 550mAh Ni-M
H
THIS SIDE UP
W
ARNING:DO NO
T
BURN OR
PUNCTURE BA
TTERIES
MADE IN CHIN
A
Battery Pack BT5633/BT682
3
3.6V 550mAh Ni-MH
THIS SIDE UP
W
ARNING:DO NO
T
BURN OR
PUNCTURE BA
TTERIE
S
MADE IN CHIN
A
Battery Pack BT5633/BT682
3
3.6V 550mAh Ni-MH
Plug the battery
securely into the
plug inside the
handset battery
compartment,
matching the color-
coded label. Insert the supplied
battery with the
label
THIS SIDE
UP facing up as
indicated.
Align the cover flat
against the battery
compartment
cover, then slide
it upwards until it
clicks into place.
Step 3 Step 2 Step 1
5