5 – remove factory radio – Myron&Davis NV7SFT1 User Manual

Page 5

Step 1. Remove the six mounting

screws on side both sides of the radio

Step 2. Pull the radio straight out.

Step 1a. Remove factory radio

and disconnect .

Step 1b. Remove the factory

radio.

Remove the OEM Radio and prepare the Myron and Davis Unit for installation by

following the steps below.

Note

: Inspect all fasteners and brackets for damage. Replace as necessary before the

installation process is started

5 – Remove Factory Radio

Step 3. Relocate this box inside the

dash behind the radio.

Step 4. Remove the vents from the

factory trim bezel

Step 5. Re-install the vents in the

M&D radio bezel.