Technical data, 2 if the drying results are not satisfactory – Electrolux EDC2086PDW User Manual
Page 29

Problem
Possible solution
Make sure that the options are applicable
to the programme.
The display shows E51)
Deactivate and activate the appliance.
Start a new programme. If the problem oc-
curs again, contact the Service.
1) After maximum 5 hours, the programme ends automatically
10.2 If the drying results are not
satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The condenser is clogged.
• There was too much laundry in the ap-
pliance.
• The drum is dirty.
• Incorrect setting of the conductivity
sensor.
• The airflow slots are clogged.
11. TECHNICAL DATA
Dimensions (mm)
Width / Height / Depth
600 / 850 – 865 / 600
Max. depth
(with the appliance door open)
1090 mm
Max. width
(with the appliance door open)
950 mm
Electrical connection
Voltage
230 V
Frequency
50 Hz
Fuse
16 A
Total power
2800 W
Drum volume
118 l
Weight of the appliance
41 kg
Laundry: max. weight
8 kg
Type of use
Household
Ambient temperature
Min.
5 °C
Max.
35 °C
Energy consumption
1)
kWh/cycle
4,79 kWh
Annual energy consumption
2)
560 kWh
Energy efficiency class
B
Power consumption
Left-on mode
0,55 W
Off-mode
0,55 W
1) With reference to EN 61121. 8 kg of cotton centrifuged at 1000 rpm.
2) Energy consumption per year in kWh, based on 160 drying cycles of the standard cotton
programme at full and partial load, and the consumption of the low-power modes. Actual
ENGLISH
29