Asus K8S-MX - Manual (Page 52)

2-16 Chapter 2: BIOS Setup
Bank Interleaving [ Disabled]
Sets whether to allow memory accesses to be spread out over BANKS on the
same node or across nodes, decreasing access contention.
Configuration options: [Auto] [Disabled]
Node Interleaving [Disabled]
Sets whether to allow memory accesses to be spread out over NODES on the
same node or across nodes, decreasing access contention.
Configuration options: [Auto] [Disabled]
Burst Length [ 8 Beats]
Sets the burst length. Set to 4 beats to use 64 Bit Dq.
Configuration options: [8 Beats] [4 Beats]
Memclock Mode [ Auto]
Allows you to set the memory clock mode. Set by the code using [Auto] or select
[Manual] to set using one of the standard values.
Configuration options: [Auto] [Limit]
CAS Latency (CL) [Auto]
Sets the CAS Latency. Configuration options: [Auto] [2.0] [3.0] [2.5]
TRCD [Auto]
Sets the TRCD.
Configuration options: [Auto] [2 CLK] [3 CLK] [4 CLK] [5 CLK] [6 CLK]
TRP [Auto]
Sets the TRP.
Configuration options: [Auto] [2 CLK] [3 CLK] [4 CLK] [5 CLK] [6 CLK]
TRAS [Auto]
This item sets the TRAS.
Configuration options: [Auto] [5 CLK] [6 CLK] [7 CLK] [8 CLK] [9 CLK] [10 CLK] [11
CLK] [12 CLK] [13 CLK] [14 CLK] [15 CLK]