Electrolux EDH3498RDL - Manual (Page 11)

on the display. You can confirm it or set
the different language.
To set the different language:
1. Press the
or touchpad to set
your language
2. To memorise the selection press the
Start/Pause touchpad.
You can change the language each time
you want ( see Settings chapter).
7.2 Starting a programme
without delay start
1. Prepare the laundry and load the ap-
pliance.
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and op-
tions for the type of load.
• The display shows the programme
duration.
4. Press the Start/Pause touchpad, the
programme starts.
CAUTION!
Make sure that when you close
the door, the laundry does not
catch between the appliance door
and the rubber seal.
7.3 Starting the programme with
delay start
1. Set the correct programme and op-
tions for the type of load.
2. Press the delay start button again and
again until the display shows the delay
time you want to set.
• You can delay the start of a pro-
gramme from a minimum of 30 mi-
nutes to a maximum of 20 hours.
3. Press the Start/Pause touchpad, the
countdown starts. The display shows
the countdown of the delay start.
• When the countdown is completed,
the programme starts.
7.4 Auto Off function
To decrease the energy consumption, this
function automatically deactivates the ap-
pliance:
• After 5 minutes if you do not start the
programme.
• After 5 minutes from the end of the pro-
gramme.
7.5 Change a programme
1. Press the on/off button to deactivate
appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.
7.6 At the end of the
programme
When the programme is completed,
• An intermittent acoustic signal oper-
ates.
• The indicator is on.
• The Start/Pause indicator is on.
The appliance continues to operate with
the crease guard phase for approximately
other 30 minutes.
The crease guard phase removes creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is al-
most completed or completed.
When the crease guard phase is comple-
ted:
• The indicator is on.
• Start/Pause indicator goes off.
1. Press the on/off button to deactivate
the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Always clean the filter and empty
the water container when a pro-
gramme is completed.
ENGLISH 11