Avanti WC 602D - Manual (Page 9)

9
IMPORTANT SAFETY INSTRUCTIONS
?
WARNING
?
To reduce the risk of fire, electrical shock, or
injury when using your Wine/Beverage Cooler,
follow these basic precautions:
?
Read all instructions before using the Wine/Beverage Cooler.
?
DANGER or WARNING: Risk of child entrapment.
Child entrapment and suffocation are not problems of the past. Junked or abandoned
appliances are still dangerous . . . even if they will “just sit in the garage a few days”.
?
Before you throw away your old Wine/Beverage Cooler: take off the door. Leave the
shelves in place so that children may not easily climb inside.
?
Never allow children to operate, play with, or crawl inside the Wine/Beverage Cooler.
?
Never clean Wine/Beverage Cooler parts with flammable fluids. The fumes can create a
fire hazard or explosion.
?
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of
this or any other appliance. The fumes can create a fire hazard or explosion.
-Save these instructions-
INSTALLATION INSTRUCTIONS
? Before Using Your Wine/Beverage Cooler
?
Remove the exterior and interior packing.
?
Check to be sure you have all of the following parts:
?
6 Chrome Shelves
?
1 Chrome Rack
?
2 Keys
?
1 Stainless Steel Handle Assembly
?
Instruction Manual
?
Before connecting the Wine/Beverage Cooler to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system
from handling during transportation.
?
Clean the interior surface with lukewarm water using a soft cloth.
?
Install the stainless steel handle at the left side of the glass door.
? Installation of Your Wine/Beverage Cooler
?
This appliance is designed to be free standing only, and should not be recessed or built-in
(fully recessed).
?
Place your Wine/Beverage Cooler on a floor that is strong enough to support it when it is fully
loaded. To level your Wine/Beverage Cooler, adjust the adjustable leg at the bottom of the
unit.
?
Allow 5 inches of space between the back and sides of the unit, which allows the proper air
circulation to cool the compressor.
?
Locate the Wine/Beverage Cooler away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. Extreme cold ambient temperatures may also cause the unit
not to perform properly.
?
Avoid locating the unit in moist areas.
?
Plug the Wine/Beverage Cooler into an exclusive, properly installed -grounded wall outlet. Do
not under any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified electrician
or an authorized Avanti Products service center.