Electrolux ERY1201FOW - Manual (Page 13)

CARE AND CLEANING
CAUTION!
Unplug the appliance before carry-
ing out any maintenance operation.
This appliance contains hydrocar-
bons in its cooling unit; mainte-
nance and recharging must there-
fore only be carried out by author-
ized technicians.
PERIODIC CLEANING
The equipment has to be cleaned regularly:
• clean the inside and accessories with
warm water and bicarbonate of soda (5
ml to 0,5 liter of water)
• regularly check the door seals and wipe
clean to ensure they are clean and free
from debris
• rinse and dry thoroughly.
Do not pull, move or damage any
pipes and/or cables inside the cab-
inet.
Never use detergents, abrasive
powders, highly perfumed cleaning
products or wax polishes to clean
the interior as this will damage the
surface and leave a strong odour.
Once a year remove the ventilation grill at
the base of the appliance and clean the air
channels with a vacuum cleaner. This oper-
ation will improve the performance of the
appliance and save electricity consump-
tion.
CAUTION!
Take care of not to damage the
cooling system.
Many proprietary kitchen surface cleaners
contain chemicals that can attack/damage
the plastics used in this appliance. For this
reason it is recommended that the outer
casing of this appliance is only cleaned with
warm water with a little washing-up liquid
added.
After cleaning, reconnect the equipment to
the mains supply.
DEFROSTING OF THE REFRIGERATOR
P F
Frost is automatically eliminated from the
evaporator of the refrigerator compartment
every time the motor compressor stops,
during normal use. The defrost water drains
out through a trough into a special contain-
er at the back of the appliance, over the
motor compressor, where it evaporates.
It is important to periodically clean the de-
frost water drain hole (F) situated under the
salad drawers to prevent the water over-
flowing and dripping onto the food inside.
Use the special cleaner provided (P), which
you will find already inserted into the drain
hole.
DEFROSTING THE FREEZER
A certain amount of frost will al-
ways form around the top com-
partment.
Defrost the freezer when the frost
layer reaches a thickness of about
3-5 mm.
To remove the frost, do these steps:
1. Switch off the appliance.
ENGLISH 13