Electrolux ESL6391RA - Manual (Page 27)

6.3 Filling the rinse aid dispenser
M AX
1 2 3
4 + -
A B
D
C
1. Press the release button (D) to open
the lid (C).
2. Fill the rinse aid dispenser (A), no
more than the mark 'max'.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
You can turn the selector of the
released quantity (B) between po-
sition 1 (lowest quantity) and posi-
tion 4 (highest quantity).
7. DAILY USE
1. Open the water tap.
2. Press the on/off button to activate the
appliance.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
• If you use the combi detergent tab-
lets, activate the Multitab option.
5. Set and start the correct programme
for the type of load and the degree of
soil.
7.1 Using the detergent
20
30 M AX
1 2 3
4 + -
A B
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
7.2 Setting and starting a
programme
The Auto Off function
To decrease the energy consumption, this
function automatically deactivates the ap-
pliance a few minutes after:
• You have not closed the door to start
the programme.
• The programme is completed.
Reset function
For some settings it is necessary that the
appliance is in user mode.
ENGLISH 27