Electrolux EHS3920HOX - Manual (Page 10)

• There is a risk of fire when the appli-
ance is in connection with an extension
cable, an adapter or a multiple connec-
tion. Make sure that the ground con-
nection agrees with the standards and
regulations.
• Do not let the power cable to heat up
to a temperature higher than 90° C.
Make sure that you connect the blue neu-
tral cable to the terminal with a letter "N"
on it. Connect the brown (or black) phase
cable to the terminal which has a letter
"L". Keep the phase cable connected at
all times.
8.3 Replacement of the
connection cable
To replace the connection cable use only
H05V2V2-F T90 type. Make sure that the
cable section is applicable to the voltage
and the working temperature. The yellow/
green earth wire must be approximately 2
cm. longer than the brown (or black)
phase wire.
8.4 Building in
40-50 mm
55 mm
30 mm
min. 650 mm
490 mm
min. 100 mm
270 mm
If two or more 30 cm hobs are to be in-
stalled side by side into the same cut out,
an assembly kit is available at our Service
Centres. The kit contains a support side
bracket, supplementary seals and the in-
stallation instructions.
Put the seals supplied with the hob on the
edge of the cut out. Make sure that the
ends fit together without overlapping.
A
B
A) Supplied seal
B) Supplied brackets
CAUTION!
Install the appliance only on a
worktop with flat surface.
8.5 Possibilities for insertion
Kitchen unit with door
The panel installed below the hob must
be easy to remove and let an easy access
in case a technical assistance intervention
is necessary.
min 20 mm
(max 150 mm)
30 mm
60 mm
B
A
A) Removable panel
B) Space for connections
10 www.electrolux.com