Electrolux EWF1286GDW User Manual

Page 22

Problem

Possible solution

Make sure that the water tap is not clogged.

Make sure that the filter of the inlet hose and the filter of the

valve are not clogged. Refer to “Care and cleaning”.

Make sure that the inlet hose has no kinks or bends.

Make sure that the connection of the water inlet hose is cor-

rect.

The appliance does not

fill with water and drain

immediately.

Make sure that the drain hose is in the correct position. The

hose may be too low.

The appliance does not

drain the water.

Make sure that the sink spigot is not clogged.

Make sure that the drain hose has no kinks or bends.

Make sure that the drain filter is not clogged. Clean the filter,

if necessary. Refer to 'Care and cleaning'.

Make sure that the connection of the drain hose is correct.

Set the drain programme if you set a programme without

drain phase.

Set the drain programme if you set an option which ends

with water in the tub.

The spin phase does not

operate or the washing

cycle lasts longer than

usually.

Set the spin programme.

Make sure that the drain filter is not clogged. Clean the filter,

if necessary. Refer to 'Care and cleaning'.

Adjust manually the items in the tub and start the spin phase

again. This problem may be caused by balance problems.

There is water on the

floor.

Make sure that the couplings of the water hoses are tight

and there is not water leakages.

Make sure that the drain hose have no damages.

Make sure you use the correct detergent and the correct

quantity of it.

You cannot open the

appliance door.

Make sure that the washing programme is finished.

Set the drain or the spin programme if there is water in the

drum.

Make sure that the appliance receives electrical power.