Asus A7A266-E - Manual (Page 33)

ASUS A7A266-E User’s Manual 33
3. HARDWARE SETUP
Connectors
3. H/W SETUP
11) Chassis Intrusion Lead (4-1 pin CHASSIS)
This requires an external detection mechanism such as a chassis intrusion monitor/
sensor or microswitch. The sensor is triggered when a high level signal is sent to
the Chassis Signal lead, which occurs when a panel switch or light detector is
triggered. This function works with an optional ASUS CIDB chassis intrusion
module (see your vendor for more details). If the chassis intrusion lead is not
used, a jumper cap must be placed over the pins to close the circuit.
0 1 0 1
A7A266-E
A7A266-E Chassis Open Alarm Lead
CHASSIS
+5V
olt
(Power Supply Stand By) Ground Chassis Signal
1
10) IDE Activity LED (2-pin IDELED)
This lead supplies power to the cabinet’s IDE activity LED. Read and write
activity by devices connected to the Primary/Secondary IDE and Primary/
Secondary ATA100 connectors will cause the LED to light up.
0 1 0 1
A7A266-E
A7A266-E IDE Activity LED
TIP: If the case-mounted LED does not
light, try reversing the 2-pin plug.
IDELED