Electrolux EWG127410W - Manual (Page 26)

BUILDING IN
OVERVIEW
This appliance has been designed to be
built into the kitchen furniture. The recess
should have the dimensions shown in Fig.
1.
Fig. 1
600 mm
555 mm
596 mm
170 mm
75 mm
100 mm
60 mm
min.
820 mm
min.
560 mm
818 mm
Preparation and assembly of the door
The appliance is originally prearranged for
the assembly of a door opening from right
to left (Fig. 2).
Fig. 2
a) Door
The dimensions of the door should be:
- width 595-598 mm
- thickness 16-22 mm
The height X depends on the height of the
adjacent furniture's base (Fig. 3).
Fig. 3
Ø 35 mm
14 mm
16-22 mm
22±1,5 mm
416
mm
X
595-598 mm
b) Hinges
To mount the hinges it is necessary to drill
two holes (dia. 35 mm, depth 12.5-14 mm
depending on the depth of door furniture)
on the inner side of the door. The distance
between the holes hobs fixing centres must
be 416 mm.
The distance from upper edge of the door
to the centre of the hole depends on the
adjacent furniture's dimensions.
The hinges will be fixed to the door by
means of screws for wood 1 and 2 (Fig. 4)
supplied with the appliance.
Fig. 4
1
2
c) Mounting the door
Fix the hinges to the appliance by means of
the M5x15 screws. The hinges can be ad-
justed to compensate for possible uneven
thickness of the door.
To align the door perfectly it is necessary to
loosen the screw, adjust the door and tight-
en the screw A again (Fig. 5).
Warning! Do not remove the screw B
(Fig. 5).
26 electrolux