Electrolux EI24ID50QS - Manual (Page 7)

7 Operating Instructions
E n e r g y O p t i o n S e l e c t i o n s
Hi-Temp
When HI-TEMP option is selected, the dishwasher
heats water in the main wash to approximately
140
0 F (60 0 C).
This increase in water temperature helps
dishwasher detergent remove food, grease and soil
from dishes more effectively and aids in drying. HI-
TEMP option can only be used with AUTO, HEAVY,
NORMAL and UPPER cycles.
Sanitize
To sanitize your dishes and glassware, select the
SANITIZE option. This option heats the water
temperature in the final rinse to 157
0 F (69.4 0 C)
and maintains that temperature for 7 minutes.
SANITIZE is available in Auto, Heavy, and Normal
cycles. Only these sanitization cycles have been
designed to meet NSF requirements.
The cycle time will be extended until the proper
water temperature is reached. Washing action will
continue during the water heating delay. For best
results, the incoming water temperature should be
at least 120
0 F (49 0 C).
If the SANITIZE option is selected, the led above
the pad comes on. The sanitization criteria may
not be satisfied if there is an interruption of the
cycle, a power failure occurs, or if incoming water
temperature is below 120
0 F (49 0 C).
Sanitize led flashes at the end of the cycle if the
NSF requirements for sanitization are not reached.
Child Lock Controls/Air Dry
To prevent children from accidently changing the
dishwasher cycle or starting the dishwasher, lock
the dishwasher controls by pressing the AIR DRY
pad until “Loc” shows in the status window. The
controls are locked and no new selections can
be made until the lock is released. To unlock
the controls, press the AIR DRY pad until “Loc”
disappears. If child lock is activated the dishwasher
will not work.
Max Dry
MAX DRY is available on Auto, Heavy, Normal,
Upper and Stemware cycles The cycle time will
increase when MAX DRY option is selected.
O p e r a t i o n S e l e c t i o n
Delay
The Delay Start option allows you to automatically
delay starting your dishwasher from 1 to 24 hours.
Press DELAY pad until the desired delay time
shows in the Status window then press START to
activate. Display will indicate the delay start time
and will countdown until cycle starts.
To cancel the DELAY option and begin the cycle
before the delay period is over, press the CANCEL
pad and then the START pad.
To start a cycle, press the START pad once and
close the door.
To cancel a cycle at anytime, open the door and
press the START/CANCEL pad until the 1 min drain
feature is initiated. Close the door and the drain
cycle will begin. You will hear a tone for the start
and completion of the drain cycle. When the door
is opened, the last cycle selected will be displayed.
If desired, a new cycle can now be selected by
pressing START/CANCEL pad and upon closing
the door the cycle will begin.
Start
Cancel